The wider side of case study answer holes should be aligned to case study solution length of case study answer board. As you attach case study solution first board on case study answer joist, pay close consideration to case study solution alignment of case study answer board and confirm that case study solution edge is directly. Once case study answer first board is in place, you may now attach case study answer T Clips to case study solution entire stretch of case study answer boards inner edge using case study solution long shaft power screwdriver. Make sure that you just adjust case study solution drill torque to make sure T Clips are tightly fixed, but be careful not to make case study answer T clips too tight; case study solution board may chip and it can be challenging so that you can attach case study solution next boards. To attach case study answer additional boards to your deck, align case study answer groves on case study solution second board with case study solution T clips of case study answer first board, then use a hammer to slip case study solution board into place. To avoid ugly dents in your board, use a hammer with a rubber face and faucet frivolously on case study solution board to insert it into place.